| 接送料的工作台面应和切刀下部保持水平 |
| 添加时间：2019/11/7 15:57:41 浏览次数： |
| (1)接送料的工作台面应和切刀下部保持水平，工作台的长度可根据加工材料长度确定。加工较长的钢筋时，应有专人帮扶，并听从操作人员指挥，不得任意推拉。 (1) the worktable for receiving and delivering materials shall be level with the lower part of the cutter, and the length of the worktable can be determined according to the length of the processed materials. When processing long steel bars, there should be a special person to help and follow the command of the operator, and it is not allowed to push or pull arbitrarily. (2)启动前，必须检查切刀应无裂纹，刀架螺栓紧固，防护罩牢靠。然后用手转动皮带轮，检查齿轮啮合间隙，调整切刀间隙。 (2) before start-up, the cutter must be checked to ensure that there is no crack, the bolt on the cutter head is fastened and the protective cover is secure. Then turn the pulley by hand, check the gear engagement clearance and adjust the cutter clearance. (3)启动后，应先空运转，检查各传动部分及轴承运转正常，方可操作。 (3) after start-up, it is required to run the machine idly first, and check that all transmission parts and bearings operate normally before operation. (4)机械未达到正常转速时不得切料。切断时必须使用切刀的中、下部位，握紧钢筋对准刀口迅速送入，操作者应站在固定刀片一侧用力压住钢筋，应防止钢筋末端弹出伤人。严禁用两手分在刀片两边握住钢筋俯身送料。 (4) do not cut the material when the machine does not reach the normal speed. During cutting, the middle and lower parts of the cutter must be used, and the steel bar shall be tightly held to align with the knife edge and quickly fed in. The operator shall stand on the side of the fixed blade and press the steel bar firmly to prevent the end of the steel bar from popping and hurting people. It is forbidden to use two hands to hold the steel bars on both sides of the blade and bend over to feed. |
| 上一页 吊装带作业方案 |
| 下一页 插编钢丝绳吊索外观 |
Copyright © 技术支持：遨游网络