钢丝绳插编吊索：
Wire rope insertion sling:
1、索扣的实际破断强度应至少为相应钢丝绳的最小破断拉力的70％。
1. The actual breaking strength of the cable should be at least 70% of the minimum breaking tension of the corresponding wire rope.
注：如果钢丝绳为金属芯的，则金属芯应至少穿插三次，可以把它看作是钢丝绳的承载部分。
Note: If the wire rope is metal core, the metal core should be inserted at least three times, which can be regarded as the load-bearing part of the wire rope.
2、在单根吊索中，每一端索扣的插编部分的最小距离不得小于钢丝绳公称直径的10倍。
2. In a single sling, the minimum distance of the insertion part of each end of the cable buckle shall not be less than 10 times the nominal diameter of the wire rope.
插编钢丝绳吊索外观
Appearance of inserting wire rope sling
1、插编部分的绳芯不得外露，各股要紧密，不能有松动的现象。
1. The cores of the insertion part shall not be exposed, and the stocks shall be tight and shall not be loosened.
2、插编后的绳股切头要平整，不得有明显的扭曲。
2. The cut ends of the rope strands after insertion should be flat and not be obviously distorted.
3、根据需方的要求，插编的绳股钢丝端部应采用合适的被覆物包扎，但应在合同中注明。
3. According to the requirement of the demander, the end of the inserted rope strand steel wire should be wrapped with suitable covering, but it should be specified in the contract.